Wet Removal And Dry Disposal Method For Asbestos Extraction

Asbestos was widely used in building materials from the 1940s to the late 1980s. This material is used because it is durable, fireproof and is a very effective insulating material. This is a common trait in most old houses. Once the health risks associated with its use have been identified, asbestos is no longer mined or extracted in Australia.

It has not been imported or used in Australian-made products since early 2004. In fact, its elimination is encouraged in situations where it poses a health risk. However, the U.S. Environmental Protection Agency. recommends that if the asbestos is persistent, it should be left alone, as touching or damaging it can cause even greater harm. As asbestos is very dangerous for health it should be removed with some precautions. To know about the effective asbestos removal precautions visit www./rynosasbestos.com.au/asbestos-removal/.

1. Wet removal method

This method is the most preferred. The asbestos fibres are pressed by pouring water under minimal pressure, so the likelihood of the fibres falling into the air is reduced. There is little or no dust due to low-pressure water. If necessary, preparations to increase the absorption rate can be added to low-pressure water. During activities, the bathroom surface must be kept wet at all times. This is a great way to remove asbestos bathroom tiles.

2. Dry disposal method

This method can be used in situations where water can be a safety hazard, eg. when working on power cords and cables in the bathroom. Another situation is when displacement is carried out in an area that is completely or partially covered.